anonymous
  • anonymous
which will be a good book for studying robotics.. :)
Engineering
schrodinger
  • schrodinger
See more answers at brainly.com
At vero eos et accusamus et iusto odio dignissimos ducimus qui blanditiis praesentium voluptatum deleniti atque corrupti quos dolores et quas molestias excepturi sint occaecati cupiditate non provident, similique sunt in culpa qui officia deserunt mollitia animi, id est laborum et dolorum fuga. Et harum quidem rerum facilis est et expedita distinctio. Nam libero tempore, cum soluta nobis est eligendi optio cumque nihil impedit quo minus id quod maxime placeat facere possimus, omnis voluptas assumenda est, omnis dolor repellendus. Itaque earum rerum hic tenetur a sapiente delectus, ut aut reiciendis voluptatibus maiores alias consequatur aut perferendis doloribus asperiores repellat.

Get this expert

answer on brainly

SEE EXPERT ANSWER

Get your free account and access expert answers to this
and thousands of other questions

anonymous
  • anonymous
i prefer video lectures over books
anonymous
  • anonymous
which lectures?? any site plz... :)
anonymous
  • anonymous
IIT: http://nptel.iitm.ac.in/video.php?subjectId=112101099 STANFORD UNIVERSITY: http://see.stanford.edu/see/lecturelist.aspx?coll=86cc8662-f6e4-43c3-a1be-b30d1d179743 MIT : http://ocw.mit.edu/courses/electrical-engineering-and-computer-science/6-832-underactuated-robotics-spring-2009/ http://ocw.mit.edu/courses/mechanical-engineering/2-12-introduction-to-robotics-fall-2005/ hope it helps

Looking for something else?

Not the answer you are looking for? Search for more explanations.

More answers

anonymous
  • anonymous
Robotics doesn't fit in a book. Depending on what you are trying to do with robotics you may need to learn any number of things. Classical control theory is a good building block for a lot of actuator control. Clever mechanical engineer may enable you to get around control issues. If you are doing some sort of custom construction then electronics knowledge will be need to at the very least contain magic smoke as you are hooking things up. The software side is wide open based on what sensors you are using, vision processing, fuzzy logic the list goes on and on. I would recommend that you pick some hardware (Mindstorm, BoeBot, Arduino) then figure out what you can do with that and learn how to do it. Yes there is a bit of a chicken and egg problem there.
anonymous
  • anonymous
thanks Joe

Looking for something else?

Not the answer you are looking for? Search for more explanations.