At vero eos et accusamus et iusto odio dignissimos ducimus qui blanditiis praesentium voluptatum deleniti atque corrupti quos dolores et quas molestias excepturi sint occaecati cupiditate non provident, similique sunt in culpa qui officia deserunt mollitia animi, id est laborum et dolorum fuga. Et harum quidem rerum facilis est et expedita distinctio. Nam libero tempore, cum soluta nobis est eligendi optio cumque nihil impedit quo minus id quod maxime placeat facere possimus, omnis voluptas assumenda est, omnis dolor repellendus. Itaque earum rerum hic tenetur a sapiente delectus, ut aut reiciendis voluptatibus maiores alias consequatur aut perferendis doloribus asperiores repellat.
#2: A pump contains 0.5 L of air at 203 kPa. You draw back on the piston of the pump, expanding the volume until the pressure reads 50.8 kPa. What is the new volume of air in the pump? A. 0.2 L B. 1.0 L C. 2.0 L D. 4.0 L **my answer: C. 2.0 L is that right? :/
yep, by squeezing the ballon you decrease the volume and increase the frequency of collisions since they're more "crowded"
#3: You place a balloon in a closed vacuum chamber at STP. You reduce the chamber pressure by half. What happens to the balloon? A. It reduces in size by half. B. It stays the same volume. C. It doubles in volume. D. It expands to four times the volume. **my answer: A is that right?
2 is good (Y) P1V1=P2PV2
3. is not correct. think about what happens if you reduce the pressure..
#4: A balloon contains 0.5 L of air at 101.5 kPa. You squeeze it to a volume of 0.25 L. What is the pressure of air inside the balloon? A. 0.25 kPa B. 50.8 kPa C. 102 kPa D. 203 kPa **ym answer; D. 203kPa is that right?
so would 3 be it doubles in volume? answer choice C?
4 is good
#5: This question appears on a quiz: "A 1.0 L balloon has a pressure of 2 atm. When the pressure increases to 1,000 kPa, what is the volume?" A student answers 0.002 L. Which of the following explanations is correct? A. The student did not solve for the correct parameter, and the answer should be 2.0 L. B. The student did not solve for the correct parameter, and the answer should be 0.5 L. C. The student did not put the pressures in the same units, and the answer should be 0.5.L. D. The student did not put the pressures in the same units, and the answer should be 0.2 L. ***my answer; D is that right?
well, does that make sense to you?
kinda... i was debating between A and C for #3... but I'm not too sure haha :/ but if it isn't A, then is it C?
5 is good!
yep it's C, the balloon will expand because you're putting less pressure on it's walls
awesome!!! :) thanks so much!!! :)
no problem:) i'm gonna walk over to the library, see ya!
okay haha see ya!! :)