Delete
Share
This Question is Closed
gerryliyana
Best Response
You've already chosen the best response.
0
@ivanmlerner
gerryliyana
Best Response
You've already chosen the best response.
0
@mukushla
rohankv
Best Response
You've already chosen the best response.
1
Consider Hooke's Law which says within a certain limit stress is proportional to strain.
As rods are made up of same material proportionality constant are same then solve
the problem
gerryliyana
Best Response
You've already chosen the best response.
0
i knew..., i've tried.., but not work
rohankv
Best Response
You've already chosen the best response.
1
You might consider it again.......you can check on compressive/tensile stress signs
gerryliyana
Best Response
You've already chosen the best response.
0
what did you get it??
rohankv
Best Response
You've already chosen the best response.
1
It doesn't matter
rohankv
Best Response
You've already chosen the best response.
1
I got 4.7746 mm
gerryliyana
Best Response
You've already chosen the best response.
0
still doesn't work
rohankv
Best Response
You've already chosen the best response.
1
Be cautious about substituting the area.....circular cross sections....square cross
sections...